oh you little dummy not this way!
you must make a line at about 30* from the vertical
revolve, copy the lil’ sausage and flip it, until you have got a 360* rotated cilinder, then again copy it and paste it, selecting as anchor point the center of the circle.
in the tip you just turn it and go down with it

happy?

sady, I doubt that you would be encouraged by someone calling you names, even if they did have good suggestions. :)

checkout this one
http://www.3dvia.com/toymaker/models/8499A5BA8C9EB082

sorry don i do not understand

Your modeling suggestions are good, but calling anyone a “little dummy” is not going to make them happy. :)

dummy is not such a bad word
i told it into a friendly kind

Well I guess since I don’t want to delete your comments I will allow it this ONCE.